دبلومة تصميم دوائر كلاسيك كنترول
البرنامج التدريبي
Classic control
Digital Instrumentation
Protection
ATS
–Classic control
-type of electrical load
-type of mechanical load
-matching between motor curve and mechanical load curve
– Characteristics of 3phase induction motor
Introduction to control system.-
Types of electrical key.-
Push Buttons,Relay,latch relay, solid state relay-
Different between power &control circuit.-
Design control diagram for any control system-
How to using simulation Programs EKTS , Automation Studio –
Theory of contactor Action.-
applications Different application by using relay and contactor –
Timers-
Different type of timers-
applications Different application by using timer-
How to solve timing diagram-
Different application by timing diagram-
troubleshooting –
–Digital Instrumentation
Limit switch-
– Proximity sensor
-Different between PNP &NPN proximity sensor
-reed switch
-between inductive &capacitive -pressure switch
-photo cell
-level switch
-float switch
-flow switch
-flow mac
–Protection
-Circuit breaker
-Theory operation of C.B
-fuse
-Overload relay
-Theory operation of overload
-Phase sequence theory of operation
-phase failure
-over under voltage
-safety relay
-total protection
-RCCB
-surge arrester
-motor starter
–ATS diagram with controller
-ATS diagram without controller
one out of two
two out of three
two out of four
three out of five
دورات ذات الصلة
